CLEAN MODE: positive ion export + 42℃±2℃ constant temperature hot compress + sonic vibration + blue light cleansing MOISTURE MODE: negative ion introduction + 42℃±2℃ constant temperature hot compress + sonic vibration + red light skin rejuvenation UP MODE: UP electric pulse (EMS+intermittent ultra-pulse) + 42℃±2℃ constant temperature hot compress + red light skin rejuvenation COOL MODE: 10℃±2℃ cold compress + blue light cleansing
STEP ONE: After moisturizing the face, place the frequently used cleanser on the brush area and apply it wet, and long press the power mode button to turn on the high-frequency vibration to assist deep cleansing. STEP TWO: Clean the skin, move along the contours of the face to clean the cheeks, forehead, nose and parts below the eyes. STEP THREE: complete the cleansing rinse and dry the face. Continue to use subsequent skin care steps.
STEP FOUR: Short press the power button to switch gears, after cleaning, long press the power mode button to shut down.
STEP One:Spread the gel evenly on the electrodes of the fat removal device, press and hold for three seconds to turn on, and select the mode and gear as required.
STEP TWO:Short press the SONIC key to turn on the ultrasonic and blue light mode, short press again to turn off the SONIC function, short press RF+EMS to turn on the red light mode, short press RF+EMS again to turn off the function.
Press the SONIC button and RF+EMS at the same time to turn on the fat burst purple light mode (the three functions are superimposed in this mode)!